Tuesday, May 21, 2019

2010 Land Rover Range Rover (LM) V8-5.0L Technical Service Bulletin # TECLTB004302 Date: 120726

2010 Land Rover Range Rover (LM) V8-5.0L Technical Service Bulletin # TECLTB004302 Date: 120726



Collision Avoidance - Surround Camera Image Lost



LTB00430NAS2



26 JULY 2012



ISSUE 2 CHANGES ARE HIGHLIGHTED IN GRAY AND ASTERISKS



SECTION: 418-02



Surround Camera System Camera Equalizers



AFFECTED VEHICLE RANGE:



CONDITION SUMMARY:



Situation:



On vehicles fitted with the Surround Camera System (not vehicles fitted with Parking Aid - Rear View Camera only), the camera image may be lost



and a blue screen is displayed.



Cause:



This may be caused by signal loss through the coax.



*NOTE: LR4 and Range Rover Sport vehicles experiencing a rear or front bumper camera blue screen concern and eligible for Service Action



Q179, perform the Repair Procedure as described in Technical Bulletin Q179NAS.*



NOTE:



2010 Land Rover Range Rover (LM) V8-5.0L Page 15



For Range Rover vehicles experiencing a rear camera blue screen concern and eligible for Service Action Q140, perform the Repair Procedure



as described in Technical Bulletin Q140NAS. For vehicles experiencing an issue with a camera where an equalizer kit is not available, refer to



Technical Bulletin LTB00367NAS for further information.



Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below to install an equalizer kit(s).



PARTS:



TOOLS:



Refer to Workshop Manual for any required special tools



WARRANTY:



NOTE: Repair procedures are under constant review, and therefore times are subject to change;



those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.



DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.



Normal Warranty policies and procedures apply



REPAIR PROCEDURE



INSTALL NEW SURROUND CAMERA SYSTEM CAMERA EQUIALIZERS



NOTE:



Do not replace all camera equalizers. Only install a camera equalizer to a circuit which is displaying no image / blue screen.





1. Refer to Workshop Manual, section 418-02: Wiring Harnesses, and install new camera equalizers.





2. Verify Surround Camera System camera operation:



^ If the image is lost or a blue screen is displayed, refer to Technical Bulletin LTB00367NAS for further information.

No comments:

Post a Comment