2010 Land Rover Range Rover (LM) V8-5.0L Technical Service Bulletin # TECLTB004193 Date: 120523

2010 Land Rover Range Rover (LM) V8-5.0L Technical Service Bulletin # TECLTB004193 Date: 120523

Body - Door Mirror Wind Noise

TECHNICAL BULLETIN

LTB00419NAS3

23 MAY 2012

ISSUE '3' CHANGES ARE HIGHLIGHTED IN GRAY

SECTION: 501

Door Mirror Wind Noise

AFFECTED VEHICLE RANGE:

Range Rover (LM)

VIN: AA304426 - *CA383407*

Model Year: 2010 - 2012

CONDITION SUMMARY:

Situation:

A wind noise may be heard from the left or right front door mirror(s). This may be caused by air penetration between the mirror and the door mating

surface Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below to insert a Nitto foam pad at the door

mirror mounting area.

PARTS:

NOTE:

The Nitto foam should be locally sourced from the Squeaks & Rattles Kit and must be claimed as 'sublet' using code 'other' (up to $3.09).

Nitto foam - locally sourced from the Squeaks & Rattles Kit

TOOLS:

Refer to Workshop Manual for any required special tools

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance

only. Always refer to DDW to obtain the latest repair time.

NOTE:

The Nitto foam should be locally sourced from the Squeaks & Rattles Kit and must be claimed as 'sublet' using code 'other' (up to $3.09).

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal Warranty policies and procedures apply

2010 Land Rover Range Rover (LM) V8-5.0L Page 31

REPAIR PROCEDURE

INSTALL NITTO FOAM PAD TO MIRROR MOUNTING AREA

1. Refer to Workshop Manual, section 501-09: Rear View Mirrors, and remove the door mirror.

2. Identify the cavity.

3. Identify the area to be covered by the Nitto foam.

CAUTION:

Make sure that the pad does not interfere with the mirror assembly.

4. Install the pad.

^ Cut the locally sourced Nitto foam from the Squeaks & Rattles Kit into a 25mm X 15mm rectangle.

^ Install in to the location shown.

5. Refer to Workshop Manual, section 501-09: Rear View Mirrors, and install the door mirror.

6. If necessary, repeat steps 1 - 5 to the opposite door / mirror.