2010 Land Rover LR2 (LF) L6-3.2L Technical Service Bulletin # TECLTB00161 Date: 081007
Drivetrain - Revised R/I Of The Active On-Demand Coupler Module
No: LTB00161
Issue: 1
Date: 07 OCT 2008
SECTION: 205
New Workshop Procedure - Remove / Install the Active
On-Demand Coupling Module
AFFECTED VEHICLE RANGE:
2010 Land Rover LR2 (LF) L6-3.2L Page 83
LR2 (LF)
VIN: 8H000212 - Onwards
Model Year: 2008 - Onwards
CONDITION SUMMARY:
Situation:
The procedure to remove / install the Active On-Demand Coupling Module has been revised. It is no longer necessary to drain and refill the oil
within the unit.
Action:
In the event it becomes necessary to remove / install the Active On-Demand Coupling Module, refer to the Repair Procedure outlined below.
PARTS:
No parts necessary; information only
TOOLS:
Refer to Workshop Manual (GTR) for any required special tools
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.
Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal warranty policy and procedures apply.
REPAIR PROCEDURE:
REPLACE ACTIVE ON-DEMAND COUPLING MODULE
NOTE:
Global Technical Reference (GTR) lookup sequence is as follows:
GTR Home > NAS > LF-LR2 > Service Information > Model Year > Workshop Manual >
2: Chassis > 205-02 > Rear Drive Axle / Differential > Active On-Demand Coupling Module (51.30.03)
1. Refer to Workshop Manual (GTR) Section 51.30.03 to remove / install the Active On-Demand Coupling Module.
No comments:
Post a Comment