Tuesday, April 23, 2019

Disclaimer2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB00416 Date: 111201

Disclaimer2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB00416 Date: 111201



Suspension - Adaptive Dynamics Damper Wire Damage



LTB00416NAS1



01 DEC 2011



SECTION: 418



Adaptive Dynamics Front Damper Wires Damaged



AFFECTED VEHICLE RANGE:



Range Rover (LM) VIN: AA304426 - Onwards



Model Year: 2010 - Onwards



CONDITION SUMMARY:



Situation:



The "Adaptive Dynamics Fault" message may be displayed in the message center with Diagnostic Trouble Codes (DTC) C1024-00, C110C-14,



2010 Land Rover Range Rover (LM) V8-5.0L SC Page 47



C110D-14, and C110D-19 stored in the Adaptive Damping control module. This may be due to damaged wires at the Adaptive Dynamics front



damper(s) caused by rotation of the front dampers during normal driving.



Action:



In the event of a customer concern of the above, refer to the Repair Procedure outlined below to repair the wiring at the affected Adaptive Dynamics



front damper(s).



PARTS



TOOLS:



IDS with latest IDS-DVD and Calibration File Land Rover-approved Midtronics Vehicle Power Supply. Refer to Workshop Manual for any required



special tools.



WARRANTY:



NOTE:



Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always



refer to DDW to obtain the latest repair time.



DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.



REPAIR PROCEDURE



INSTALL ADAPTIVE DYNAMICS FRONT DAMPER LINK HARNESS



CAUTION



Take care when removing the cover; failure to follow this instruction may result in damage to the harness.



NOTE:



Note the fitted position of the cover and the grommet before removal.



1. Remove the affected Adapted Dynamics front damper top cover: (Figure 1)



^ Remove the two (2) Torx bolts.



^ Release the grommet.



NOTE:



2010 Land Rover Range Rover (LM) V8-5.0L SC Page 48



Note the orientation of the electrical connector during removal.



2. Release the wiring harness: (Figure 2)



^ Carefully release the electrical connector.



^ Release the fir tree clip.



CAUTION



Make sure the electrical connector is correctly aligned before securing in place; failure to follow this instruction may result in damage to the vehicle.



3. Install the new wiring link harness: (Figure 3)



^ Connect the electrical connector.



^ Secure the fir tree clip.



CAUTION



Make sure that there is a sufficient length of existing wiring harness to make the connection to the new wiring harness.



2010 Land Rover Range Rover (LM) V8-5.0L SC Page 49



4. Using a suitable tool, remove the damaged section of the wiring harness. (Figure 4)



5. Using the Land Rover-approved harness repair kit, join the new wiring harness to the existing harness:



^ Make sure that the wiring harness is protected with locally-sourced suitable insulation tape.



CAUTION



Make sure that the wiring harness is not damaged during the installation of the suspension cover.



CAUTION



Make sure that the dowels are correctly aligned.



6. Install the Adapted Dynamics front damper top cover:



^ Carefully align the grommet.



^ Tighten the two (2) Torx bolts to 9 Nm.



7. Repeat steps 1 - 6, if necessary, to the opposite-side Adaptive Dynamics front damper.

No comments:

Post a Comment