- 055Measuring beaker
- 069Pressure hose(119 589 04 63 00)
Warning!On USA vehicles with code 917 ( PZEV ), the sealing ring of the service valve for the protective cap must be replaced.Test sequence
- Switch off ignition.
- Connect test pressure gauge.
- Engine at idle
Specified value
- Pressure[3.7...4.2] bar
Question
- Is the measurement value OK?
YES
The measurement value is OK.Test prerequisite
- Test pressure gage is connected.
Test sequence
- Run the engine for a short time and switch off again.
- Switch off ignition.
Specified value
- Pressure after 30 minutes:[> 2.5] bar
Question
- Is the measurement value OK?
YES
The measurement value is OK.Further possible causes of fault
- Test delivery of component M3 (Fuel pump).
NO
The measurement value is not OK.Possible cause and remedy
- In the event of slow pressure drop:Check component Y62 (Fuel injectors).
- In the event of rapid pressure drop:Check valve in component M3 (Fuel pump)
No comments:
Post a Comment