Tuesday, April 2, 2019

2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 657


- Connect socket box (126-pin) to component N3/10 (ME-SFI [ME] control unit).



- Measure direct current with multimeter between sockets (F.4) 100 and [M.53] 53 of the 126-pole socket box tester.



- Switch on ignition.



Specified value



- Amperage[0.3...0.6] A



Question



- Is the measurement value OK?



YES



The measurement value is OK.End of test



NO



The measurement value is not OK.Possible cause and remedy



- N10/1f57 (Fuse 57)



- N10/1kI (Circuit 87 relay, engine)



- Line between component N3/10 (ME-SFI [ME] control unit) and component Y32 (Air pump switchover valve)



- Line between component N10/1 (Driver-side SAM control unit with fuse and relay module) and component Y32 (Air pump switchover valve)



- Y32 (Air pump switchover valve)



End of test



0821



The secondary air valve (cylinder bank 2) is jammed open. (P2442)



Possible cause:



- Y32 (Air pump switchover valve)



Affected functions:



- Engine diagnosis



-------------------------------------------------



Test 1: Check component Y32 (Air pump switchover valve).



1. Check component Y32 (Air pump switchover valve).



Test 1.1: Test actuation of component Y32 (Air pump switchover valve).



Test 1.2: Test current consumption of component Y32 (Air pump switchover valve).



1.1. Test actuation of component Y32 (Air pump switchover valve).



Test sequence



- Switch on ignition.



- Actuate component Y32 (Air pump switchover valve).(Proceed to 'Actuation' with F2)



Warning!Communication with ECU required.



1.2. Test current consumption of component Y32 (Air pump switchover valve).



Figure legend



- A -ConnectionTest cable 35-pin socket box



- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)



- 05 -35-pin socket box



- 050 -126-pin socket box



- 108 -Test cable 266 589 01 63 00



- N3/10 (ME-SFI [ME] control unit)



- II 1-63ConnectionTest cable



- III 64-126ConnectionTest cable

No comments:

Post a Comment