2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB00366 Date: 110415
Entertainment System - DVD Docking Tray Won't Latch
No: LTB00366 (Issue 1)
15 APR 2011
SECTION: 415
Rear DVD Remote Docking Tray Not Latching
AFFECTED VEHICLE RANGE:
Range Rover (LM) VIN: AA322097 - BA343300
Model Year: 2010 - 2011
CONDITION SUMMARY:
Situation: The rear DVD remote may not latch into its docking tray. This may be caused by distortion of the docking tray.
Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below to replace the rear DVD remote docking tray.
PARTS
TOOLS:
Refer to Workshop Manual for any required special tools
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always
refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
REPAIR PROCEDURE
REPLACE THE REAR DVD REMOTE DOCKING TRAY
1. Remove the rear DVD remote control unit.
CAUTION:
2010 Land Rover Range Rover (LM) V8-5.0L SC Page 74
Use care to not damage the arm rest.
2. Use a suitable tool to release the two front retaining clips. (Figure 1)
CAUTION:
Use care to not damage the arm rest.
3. Use a suitable tool to release the two rear retaining clips. (Figure 2)
4. Remove the docking tray: (Figure 3)
^ Disconnect the electrical connector and clip.
2010 Land Rover Range Rover (LM) V8-5.0L SC Page 75
CAUTION:
Ensure the wiring is installed on both locating pegs of the new docking tray. (Figure 4)
5. Install the new docking tray: (Figure 4)
^ Connect the clip and connector.
6. Secure the two rear retaining clips. (Figure 2)
7. Secure the two front retaining clips. (Figure 1)
8. Install the rear DVD remote control unit.
No comments:
Post a Comment