2010 Land Rover LR2 (LF) L6-3.2L Technical Service Bulletin # TECLTB00349 Date: 110322

2010 Land Rover LR2 (LF) L6-3.2L Technical Service Bulletin # TECLTB00349 Date: 110322

Electrical, A/T - Battery Cable Routing With A/T R&R

No: LTB00349 (ISSUE 1)

22 MAR 2011

SECTION: 307

Cable Routing Change When Installing New Transmission

AFFECTED VEHICLE RANGE:

LR2 (LF)

VIN: 8H000212-AH172293

Model Year:

2008 - 2010

CONDITION SUMMARY:

Situation:

As a result of changes made to the transmission casing, the positive battery and starter solenoid cables routing and securing points have been

modified.

NOTE:

When replacing the transmission with a modified casing (part number LR021650 or LR023720 [or later]), the positive battery cable must be

replaced with part number LR023719 (or later) and re-routed with the starter solenoid cable to the revised securing points on the transmission

casing.

Action:

In the event it becomes necessary to install a new transmission (part number LR021650 or LR023720 [or later]), refer to the Repair Procedure

outlined below to install a new positive battery cable and properly route it with the starter solenoid cable.

PARTS:

LR023719 Battery positive cable Qty: 1

TOOLS:

Refer to Workshop Manual for any required special tools

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.

Always refer to DDW to obtain the latest repair time.

2010 Land Rover LR2 (LF) L6-3.2L Page 36

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal Warranty policies and procedures apply

REPAIR PROCEDURE

REPLACE TRANSMISSION AND POSITIVE BATTERY CABLE

1. Refer to Workshop Manual, section 307-01: Automatic Transmission / Transaxle, and remove the transmission.

2. Refer to Workshop Manual, section 303-01A: Engine - 3.2L NA-16, and remove the intake manifold.

3. Disconnect the battery positive cable from the generator. (Figure 1)

4. Remove the positive battery cable.

5. Install the new positive battery cable: (Figure 2)

^ Route cable as indicated.

6. Connect the positive battery cable to the generator:

(Figure 1)

^ Tighten nut to l2Nm (8.85lbf ft).

7. Refer to Workshop Manual, section 303-01: Engine - 3.2L NA-16, and install the intake manifold.