Electrical - Engine No Crank/No Start

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Technical Service Bulletin # 10-139 Date: 101123

Electrical - Engine No Crank/No Start

Classification: EL10-030

Reference: NTB10-139

Date: November 23, 2010

ALTIMA SEDAN, COUPE, AND HYBRID; ENGINE NO CRANK / NO START

APPLIED VEHICLES2007 - 2010 Altima Sedan (L32) with CVT only

2008 - 2010 Altima Coupe (CL32) with CVT only

2007 - 2010 Altima Hybrid (L32HV)

IF YOU CONFIRM:

The engine will not crank (or go to READY MODE - Hybrid) when pressing the push-button ignition switch and applying the brake pedal.

ACCESSORY and IGNITION ON modes can be turned on and off during this condition.

ACTION:

Install a new brake lamp switch and sub-harness with those listed in PARTS INFORMATION.

For parts replacement and installation, refer to SERVICE PROCEDURE.

NOTE:

^ This bulletin does not apply to manual transmission equipped vehicles.

^ This bulletin does not apply to Hybrid vehicles with HEV related CONSULT-III DTCs.

^ This bulletin does not apply for this incident, should it occur, if ACCESSORY and IGNITION ON modes cannot be turned on.

> Go back to ASIST and the Electronic Service Manual (ESM) for further diagnostic and repair information.

IMPORTANT:

The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE

PROCEDURE as it contains information that is essential to successfully completing this repair.

PARTS INFORMATION

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 211

CLAIMS INFORMATION

STOP LAMP SUB-HARNESS

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 212

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 213

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 214

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 215

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 216

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 217

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 218