CVT - Output Speed Sensor Service

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Technical Service Bulletin # 11-042 Date: 110420

CVT - Output Speed Sensor Service

Classification: AT11-007

Reference: NTB11-042

Date: April 20, 2011

2007-2011 ALTIMA, JUKE, ROGUE, SENTRA; CVT OUTPUT SPEED SENSOR SERVICE

APPLIED VEHICLES:

2007-2011 Altima (C/L32) QR25 ONLY

2011 Juke (F15)

2008-2011 Rogue (S35)

2007-2011 Sentra (B16) MR20 & QR25 ONLY

SERVICE INFORMATION

If the Output Speed Sensor has been removed and replaced for any reason:

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 289

NOTE:

Input/Turbine Speed Sensor does not require shims. That Sensor is flush mounted to CVT casting.

The correct number of spacer shims must be installed between the Sensor and the CVT body.

Refer above for shim number application chart.

SERVICE PROCEDURE

1. Determine required number of shims by model:

2. Assemble the Output Speed Sensor with the proper 0-ring.

3. Place bolt with attached washers through hole on the Sensor.

4. After determining the correct number of washers for the vehicle, place the shims over the portion of the bolt that is exposed below the sensor

body.

5. Assemble as seen below: Torque retaining bolt to 5.9 Nm (0.6 kg-m, 52 in-lb)

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 290