2010 Land Rover Range Rover (LM) V8-5.0L Technical Service Bulletin # TECLTB00387 Date: 110609

2010 Land Rover Range Rover (LM) V8-5.0L Technical Service Bulletin # TECLTB00387 Date: 110609

Audio System - SDARS Is Inoperative

No: LTB00387 (Issue 1)

09 JUNE 2011

SECTION: 415

SDARS Inoperative

AFFECTED VEHICLES

CONDITION SUMMARY:

2010 Land Rover Range Rover (LM) V8-5.0L Page 69

Situation:

The Satellite Digital Audio Receiver System (SDARS) may be inoperative. This may be caused if the SDARS was tuned to 1 of the 22 channel

numbers deleted at 12:01AM EDT on 4 May 2011. The SDARS receiver is unable to tune; the next step is to tune to the default channel which also

no longer exists, and SDARS appears to be inoperative.

Action:

In the event of a customer concern of the above, refer to the Repair Procedure outlined below to update the SDARS control module software.

PARTS:

No parts required

TOOLS:

IDS with latest IDS-DVD and Calibration File; first available on IDS-DVD125_V5.08 Calibration File 75 Land Rover-Approved Midtronics

Vehicle Power Supply

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always

refer to DDW to obtain the latest repair time.

REPAIR PROCEDURE

UPDATE THE SDARS CONTROL MODULE SOFTWARE

CAUTION:

Ensure all ignition "ON" / Ignition "OFF" requests are carried out; failure to perform these steps may cause damage to control modules in the

vehicle.

CAUTION:

A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module programming.

1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.

2. Turn ignition ON (engine not running).

NOTE:

IDS must be loaded with IDS-DVD125_V5.08 or later and Calibration File 75 or later.

3. Connect the IDS to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.

4. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.

5. From the Session Type selection screen, choose Diagnosis.

6. Select the Selected Symptoms tab, and then select one of the following:

^ Electrical > Information and entertainment system> Entertainment system > Audio > Audio system inoperative or

^ Electrical > Information and entertainment system> Entertainment system > Audio> Radio loses pre set stations or

^ Electrical > Information and entertainment system > Entertainment system > Audio> Radio function locks up or

2010 Land Rover Range Rover (LM) V8-5.0L Page 70

^ Electrical > Information and entertainment system> Entertainment system > Audio> Radio inoperative

7. Select continue.

8. Select the Recommendations tab.

9. From the Recommendations tab, select Run to configure the SDARS control module

^ Follow all on-screen instructions to complete this task.

10. Exit the current session.

11. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.