Wednesday, February 6, 2019

Engine Controls - MIL ON/DTC's P1421/P050E Set

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Technical Service Bulletin # 11-085 Date: 110912



Engine Controls - MIL ON/DTC's P1421/P050E Set



Classification: EC11-019



Reference: NTB11-085



Date: September 12, 2011



2008-2010 ALTIMA WITH QR25DE ENGINE;



MIL 'ON' WITH DTC P14211 P050E STORED



APPLIED VEHICLE: 2008 - 2010 Altima Sedan and Coupe (L32 and CL32)



APPLIED ENGINE: QR25DE (4-cyl) engine only



IF YOU CONFIRM:



For 2008 - 2009 Altima; DTC P1421 (Cold Start Control) is stored in the ECM



Or



For 2010 Altima; DTC P050E (Cold Start Control) is stored in the ECM.



ACTION:



1. Refer to step 2 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on.



2. If this bulletin applies, reprogram the ECM.



IMPORTANT:



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 478



The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE



PROCEDURE as it contains information that is essential to successfully completing this repair.



SERVICE PROCEDURE



1. Connect the CONSULT PC to the vehicle to begin the reprogramming procedure.



If you are not familiar with the reprogramming procedure, refer to "CONSULT- III (C-III) ECM Reprogramming" general procedure.



CAUTION



2. When you get to the ECM Reprogramming screen shown in Figure 1, confirm this bulletin applies as follows.



A. On your C-III screen, look at the Part Number column (see Figure 1):



^ If this column is blank (no part number listed), this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.



^ If a Part Number is listed, write it on the Repair Order.



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 479



B. Compare the Part Number you wrote down to the numbers in the Current ECM Part Number column in Table A.



^ If there is a match, this bulletin applies. Continue with the reprogramming procedure.



NOTE:



If there are two lines (two reprogramming options) on your C-III screen, use the one that does not have the message "Caution! Use ONLY with



NTBXX-XXX".



^ If there is not a match, this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.



3. If this bulletin applies and you have performed ECM reprogramming, the screen in Figure 2 appears when reprogramming is complete.



4. Make sure to erase DTCs from all systems.



NOTE:



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 480



During reprogramming, DTCs will set in several systems and must be erased.



5. Test drive the vehicle and make sure it operates correctly and the MIL is OFF.



^ If the MIL comes ON, go back to ASIST for further diagnostic information. Diagnosis and repairs beyond ECM reprogramming are not covered

No comments:

Post a Comment