Friday, February 8, 2019

2017 Mercedes Benz C 43 AMG Diagnostic and Repair# P-88_30-36 Date: 041008

平行进口加版奔驰gle43amg运动版最低报价多少钱

Body - Scraping Noise From Transmission Tunnel Area
Date: October 8, 2004
Order No.: P-B-88.30/36
Supersedes:
Group: 88
SUBJECT:
Model 202.022/023/024/028/029/033
Mercedes Benz C 43 AMG (202.033) V8-4.3L (113.944) Page 134
Model 203.040/061/064/065/076/081/084/261/264/281/284/740/747/764
Model 210.020/025/055/065/070/072/074/082/083/265/282
Scrapping Noise from Transmission Tunnel Area
If you receive customer reports in the above model vehicles of a scraping noise from the area of the transmission tunnel, the insulation above the
transmission may have warped and is scraping on the propeller shaft. To resolve, perform the below procedure.
  1. Make a bracket to support the transmission tunnel insulation by taking a strip of aluminum approximately 2 mm thick.

  2. Cut the strip 40 mm wide and 220 mm long.

  3. Drill a 6.5 mm diameter hole in the center (Figure 1).


Warning!
Under body components may be hot, use caution.
4. Detach central heat shield above exhaust system and slide toward the rear (Figure 2).
Mercedes Benz C 43 AMG (202.033) V8-4.3L (113.944) Page 135
  1. Remove nut retaining insulation (Figure 3, arrow).

  2. Bend aluminum strip to conform with tunnel contour.

  3. Fit aluminum strip on threaded stud and reinstall original nut.

  4. Reinstall central heat shield above exhaust system.


Note:
The following allowable labor operations should be used when submitting a warranty claim for this repair.
In Case of Warranty, use the table.

No comments:

Post a Comment