Fuel System - Rattling/Jarring Noise From Engine
21 Rattling/jarring noise from engine - 2.0 TFSI EA888 transverse
21 12 09
2027585/3
May 16, 2012.
Supersedes Technical Service Bulletin Group 21 number 12 - 08 dated March 6, 2012 for reasons listed below.
2010 Audi A3 (8PA) L4-2.0L Turbo (CBFA) Page 52
Affected Vehicles
Condition
Rattling/jarring noises from the engine compartment/exhaust system between 1800 - 2900 rpm.
Technical Background
Because of exhaust gas pulsations, the wastegate flap and rods vibrate at the start of the boost air control. This leads to rattling or jarring noises.
Production Solution
Not applicable.
Service
Fit a spring clip on the wastegate adjustment.
On vehicles with front-wheel drive:
1. Remove the noise damping according to the repair manual:
Repair Manual >> Body >> Body Exterior >> 50 Body Front >> Removal and Installation >> Noise Insulation.
2. Remove the drive shaft protection.
2010 Audi A3 (8PA) L4-2.0L Turbo (CBFA) Page 53
3. Fit the clip from the side and turn it left till the lugs slot in.
On vehicles with four-wheel drive (Quattro):
1. Remove the propshaft heat shield:
Repair Manual >> Body >> 66 Exterior Equipment >> Removal and Installation >> Underbody Trim Panels >> Heat Shields, Driveshaft
2. Reach through from behind and position the clip.
2010 Audi A3 (8PA) L4-2.0L Turbo (CBFA) Page 54
3. Fit the spring clip (Figure 4) with the part number 06J 145 220 A on the wastegate adjustment (Figure 5).
Tip:Observe the following points when fitting the spring clip:
^ The spring clip must not be overstretched. The maximum opening of the spring clip is 14 mm. In Figure 6, 1 the opening is about 10.5
mm.
^ The spring clip must be replaced after every removal.
2010 Audi A3 (8PA) L4-2.0L Turbo (CBFA) Page 55
^ After fitting the spring clip check for correct fit (Figure 7).
^ After fitting the spring clip check the position of the original circlip (Figure 6, 2) and correct it if necessary.
Warranty
2010 Audi A3 (8PA) L4-2.0L Turbo (CBFA) Page 56
Required Parts and Tools
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Thursday, February 7, 2019
2017 Audi A3 (8PA) L4-2.0L Turbo (CBFA)Technical Service Bulletin # 211209 Date: 120516
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment