Navigation Radio - Blank Screen/Screen Freezes
TECHNICAL
Bulletin No.: 09-08-44-002G
Date: August 23, 2010
Subject: Intermittent Black or Blank Screen, Radio Reset, Map Screen Stops Updating or Freezes, Voice Recognition Inoperative, Dead Battery
(Update Navigation Radio Calibration and/or Software)
Models:
2009 Buick Lucerne
2009-2011 Buick Enclave
2009 Cadillac Escalade
2009 Chevrolet Equinox
2009-2011 Chevrolet Traverse
2009-2011 GMC Acadia
2009 Pontiac Torrent
2009-2010 Saturn OUTLOOK, VUE
Equipped with Navigation Radio RPO U3R, UZR, U3U, UUM or U4H
Supercede:
This bulletin is being revised to add radio RPOs and remove both the Attention statement and the radio part number identification table. Please
discard Corporate Bulletin Number 09-08-44-002F (Section 08 - Body and Accessories).
Condition
Some customers may comment on one or more of the following conditions:
Condition 1
The following conditions may occur on all of the above mentioned models:
- Intermittent blank or black screen occurring with XM traffic alerts.
- Map screen freezes or stops updating while driving.
- Navigation radio resets upon startup, due to Language selection changes on the Driver Information Center (DIC).
Condition 2
The following conditions may occur on all of the above mentioned models except the Cadillac Escalade:
- Abnormal Rear Park Assist Chime operation, which may result in a dead battery.
- Intermittent blank or black screen at start-up or while driving.
- Intermittent blank or black screen when shifting from reverse to drive.
- Radio appears to turn on twice at engine start by showing the splash screen 2 times.
- Radio changes to FM after engine start when radio was previously tuned to XM.
2016 GMC Truck Acadia AWD V6-3.6L Page 296
- Radio momentarily stops/locks up while reading the Map Disc.
- Voice recognition is intermittently inoperative.
Note
If the following condition is observed, disconnect the negative battery cable in order to reset the radio, prior to programming the radio with the
updated software.
- Radio is inoperative or unresponsive to button press and has a black or blank screen.
Cause
These conditions may be caused by a software anomaly.
Correction
Important
Before proceeding with the update, advise the customer that the Address Book, Previous Destination data, and Preset data may be removed during
the SW update. The user will have to input this data when the update is complete.
Important
- Do not eject the disc during the update.
- Do not turn the ignition off or remove power to the radio during the update.
- Do not leave the disc in the radio after the update.
- Do not give the disc to the customer.
- The software update disc may be used to update more than one vehicle.
Condition 1
For these conditions, follow this procedure:
Technicians are to update the navigation radio software using a software update disc, P/N 20884820. The software update disc is to be obtained from
the GM Navigation Disc Center, using the GM Navigation Disc Center Contact Information below.
Navigation Radio Software Update for Cadillac Escalade Models
- Start the engine with the gear shift in PARK, and wait until the audio or navigation screen is displayed.
- Proceed to the FM audio screen and confirm the current navigation software version by pressing the CONFIG and SEEK buttons (2)
simultaneously as indicated in the above illustration. If the screen switches, select FM to display the software version. Performing this
operation may take a couple of attempts for the radio to detect the simultaneous button press. The navigation software version will be the first
four characters (1), reading from the left of the display, that is located in the middle of the screen.
Record all information shown for later reference.
3. If the navigation software version is 101F or higher (e.g.101H), the radio has the latest navigation software available and no update is
necessary. However, if the string of letters across the screen is not alphanumeric, this indicates an internal communication problem with the
radio. For this condition, refer to SI. For all other navigation software versions proceed to step 4 to continue the software update.
2016 GMC Truck Acadia AWD V6-3.6L Page 297
4. Eject the map disc from the top map DVD slot (3) by pressing the EJECT button, if the disc is installed. Load the software update disc, P/N
20884820, into the top map DVD slot (3).
5. The display will show "Update in Progress" and upon a successful software update, the screen will transition to a blue screen with "The disc
installed is not a MAP DVD" message displayed on the screen. It will take approximately five minutes to load the new software.
6. When "The disc installed is not a MAP DVD" message is displayed on the screen, eject the software update disc from the top map DVD slot.
After this software update, the disc may be used again on another vehicle. Retain the disc at the dealership.
- Confirm that the new navigation software version is 101F, using the procedure outlined in step 2 above.
- Install the customer's original map disc if it was present.
- Verify the proper operation of the Navigation Radio.
Conditions 1 and 2
For these conditions, follow both of the 2 procedures.
Navigation Radio Calibration and Software Update for All Other Models
- Start the engine with the gear shift in PARK, and wait until the audio or navigation screen is displayed after the opening screen has appeared.
- Proceed to the FM audio screen and confirm the current navigation software version by pressing the MENU and SEEK UP buttons (1)
simultaneously as indicated in the above illustration. If the screen switches, select FM to display the software version. Performing this
operation may take a couple of attempts for the radio to detect the simultaneous button press. The navigation software version will be the first
four characters (2), reading from the left of the display, that is located in the middle of the screen. The Radio Calibration will be the two
characters (3) as indicated in the above illustration.
Record all information shown for later reference.
3. If the navigation software version (2) is version 102C or higher (e.g.102D), and the radio calibration (3) is 40 or higher, the radio has the latest
navigation software and calibration available and no update is necessary. However, if the string of letters across the screen is not
alphanumeric, this indicates an internal communication problem with the radio. For this condition, refer to SI. For all other navigation
software and radio calibration versions proceed to step 4 to continue the software and calibration update.
4. A revised radio software calibration has been released to address these conditions. Reprogram the radio using the Service Programming
System (SPS) with the latest calibration available on TIS2WEB. Refer to the SPS procedures in SI.
5. During programming, the battery voltage must be maintained within the proper range of 12-15 Volts. Only use the approved Midtronics(R)
PSC 550 Battery Maintainer (SPS Programming Support Tool EL-49642) or equivalent during programming.
2016 GMC Truck Acadia AWD V6-3.6L Page 298
6. Open the front display by pressing and holding the EJECT button (1) for approximately 15 seconds. Eject the map disc from the revealed map
DVD slot by pressing the EJECT button (2) located beneath the revealed map DVD slot (3). Load the software update disc, P/N 20990141,
into the map DVD slot (3).
7. Do not push on the touch screen to close it.
Close the front display by using both hands at the four corners of the display until the display fits securely into the radio.
8. The display will show "Update in Progress" and upon a successful software update, the screen will transition to a blue screen with "The disc
installed is not a MAP DVD" message displayed on the screen. It will take approximately five minutes to load the new software.
9. When "The disc installed is not a MAP DVD" message is displayed on the screen, eject the software update disc from the map DVD slot (3).
After this software update, the disc may be used again on another vehicle. Retain the disc at the dealership.
10. Confirm that the new navigation software version is 102C, using the procedure outlined in Step 2.
- Install the customer's original map disc if it was present.
- . Verify the proper operation of the Navigation Radio.
Parts Information
Navigation software update discs are for the dealer to update the Navigation Radio software only. They DO NOT update or replace the navigation
map disc that is supplied with the vehicle. Please order these parts only as needed. There is a limited supply of these discs available. Do not order
these discs for stock. Do not give the software update disc to the customer. Navigation software discs may be used to reprogram more than one
vehicle. The first update disc for each P/N is free. Subsequent copies of the same P/N for the same dealer will cost $50 (USD). Refer to the latest
version of Corporate Bulletin Number 06-08-44-012E for additional information on how to obtain AVN software update discs.
GM Navigation Disc Center Contact Information
- Via the telephone at 1-877-NAV-DISC (1-877-628-3472)
- When calling the Navigation Disc Center for software update discs, provide the 5 digit dealer code so the order can be processed correctly.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
No comments:
Post a Comment