2013 Mercedes Benz C 63 AMG Coupe (204.377) V8-6.3L (156.985) Page 51
Campaign No.2013010010, March 2013
TO: ALL MERCEDES-BENZ CENTERS
SUBJECT:
Model 204 Model Year 2013
Software Calibration Number (SCN) Code Rear SAM
This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes- Benz vehicles, has determined that the
Software Calibration Number (SCN) of the rear SAM does not correspond to current production configuration. An authorized Mercedes-Benz dealer
will update the SCN of the rear SAM at the next workshop visit.
Prior to performing this Service Campaign:
^ Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
^ Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.
Approximately 71 vehicles are affected.
Procedure
Note:
^ Use DAS/Xentry 01/13 with all associated patches or higher.
^ Follow the steps exactly as described in DAS/Xentry.
^ Connect battery charger (battery voltage>12.5V).
^ Ensure all electrical consumers are switched-off.
^ In the event of software/SCN update issues, contact Star Diagnosis User Help Desk.
^ Refer to Star Diagnosis System (SDS) Best Practices Guide
- Connect Xentry/DAS.
- Perform SCN coding in rear SAM control unit:
Control units view / Rear SAM - Rear signal acquisition and actuation module (N10/2)/Adaptations / Configuration / SCN / SCN coding.
3. Follow on-screen instructions.
Note:
The allowable labor operation should be used when submitting a warranty claim for this repair.
Warranty Information
No comments:
Post a Comment