2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB00376 Date: 110506

2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB00376 Date: 110506

Tire Monitor System - False Warning Lamp Triggered

No: LTB00376 (Issue 1)

06 MAY 2011

SECTION: 419

Tire Pressure Monitoring System False Trigger

AFFECTED VEHICLE RANGE:

LR4 (LA) VIN: AA510742 - Onwards

Model Year: 2010 - Onwards

Range Rover Sport (LS) VIN: AA212147 - Onwards

Model Year: 2010 - Onwards

Range Rover (LM) VIN: AA302697 - Onwards

Model Year: 2010 - Onwards

CONDITION SUMMARY:

Situation:

The Tire Pressure Monitoring System (TPMS) warning light may be illuminated with the message "Tire Pressure Monitoring Fault" displayed in the

message center. The Body Control Module (BCM) will also have logged code C1D18-00 in isolation. The charging circuit emits a 125MHz

electromagnetic pulse which is picked up by the TPMS wheel sensor, causing the system to fail to localize all of the sensors.

2010 Land Rover Range Rover (LM) V8-5.0L SC Page 72

NOTE:

Replace all four (vehicle set [five low tire pressure sensors if the vehicle's spare tire / wheel is fitted with a TPMS sensor]) low tire pressure sensors

for this concern.

Action:

In the event of a customer concern of the above, refer to the Repair Procedure outlined below to replace the complete set (four or five) low tire

pressure sensors.

PARTS

TOOLS:

IDS with latest IDS-DVD and Calibration File

Land Rover-Approved Midtronics Vehicle Power Supply

Refer to Workshop Manual for any required special tools

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always

refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

REPAIR PROCEDURE

REPLACE LOW TIRE PRESSURE SENSORS

1. Refer to Workshop Manual, section 204-04: Wheels and Tires, and replace all low tire pressure sensors.

CLEAR DIAGNOSTIC TROUBLE CODES

CAUTION:

Ensure all ignition "ON" / ignition "OFF" requests are carried out; failure to perform these steps may cause damage to control modules in the

vehicle.

CAUTION:

A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module programming.

1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.

2. Turn ignition ON (engine not running).

NOTE:

IDS must be loaded with latest IDS-DVD and Calibration File.

3. Connect the IDS to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.

4. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.

2010 Land Rover Range Rover (LM) V8-5.0L SC Page 73

5. From the Session Type selection screen, choose "Diagnosis".

6. Select the "Selected Symptoms" tab, and then select:

^ Electrical > Instruments > Warning lamps > TPMS warning lamp illuminated

7. Select "continue".

8. Select the "Recommendations" tab.

9. From the Recommendations tab, select "Complete vehicle - clear all Diagnostic trouble codes"

^ Follow all on-screen instructions to complete this task.

10. Exit the current session.

11. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.