Brakes - Low Fluid Level Warning Diagnostics

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Technical Service Bulletin # 10-110 Date: 100915

Brakes - Low Fluid Level Warning Diagnostics

Classification: BR10-010

Reference: NTB10-110

Date: September 15, 2010

ALTIMA AND MAXIMA; LOW BRAKE FLUID WARNING LIGHT "ON" DIAGNOSTIC PROCEDURE

APPLIED VEHICLES:

2007-2011 Altima Coupe, Hybrid, Sedan (C/L32/HV)

2009-2011 Maxima (A35)

SERVICE INFORMATION

It is possible for brake pad wear to cause the fluid level in the master cylinder reservoir to decrease to the MIN level, turning "ON" the Low Brake

Fluid Warning Light.

If you confirm that the warning light is illuminated, perform the following procedures to inspect the vehicle and determine the proper repair method.

WARRANTY NOTE:

A low fluid level in the master cylinder reservoir due only to brake pad wear not caused by any defect is not warrantable.

INSPECTION

Use a scale to check the thickness of the front brake pads.

^ View the brake pads though the caliper body inspection hole.

1. If the remaining brake pad lining thickness is as shown above.

AND

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 445

The brake fluid level in the master cylinder fluid reservoir is at or near the MIN level line,

The drop in the brake fluid level is likely due to brake pad wear not caused by any defect.

ACTION: Add brake fluid to the reservoir.

2. If the remaining brake pad lining thickness is as shown above.

AND

The brake fluid level in the master cylinder fluid reservoir is at or below the MIN level line,

ACTION: Perform brake system inspections in accordance with the Electronic Service Manual (ESM) to determine the cause of the brake fluid

level decrease.

3. To determine if the front brake pads should be replaced, refer to the applicable ESM for front brake pad wear limit thickness information.