Saturday, January 26, 2019

2010 Land Rover LR2 (LF) L6-3.2L Technical Service Bulletin # TECLTB00391 Date: 110714

2010 Land Rover LR2 (LF) L6-3.2L Technical Service Bulletin # TECLTB00391 Date: 110714



Electrical - Battery Low/Dead For No Apparent Reason



No: LTB00391 (ISSUE 1)



14 JULY 2011



SECTION: 415



FLAT BATTERY



AFFECTED VEHICLE RANGE:



LR2 (LF) w/Navigation only VIN: 8H000212 - Onwards



Model Year: 2008 - Onwards



CONDITION SUMMARY:



Situation:



The vehicle's battery may be flat, for no apparent reason, after the vehicle is parked overnight or similar period of non-use. This may be caused by



the Infotainment Control Module not shutting down correctly if the following conditions occurred at the time of ignition OFF and exiting the vehicle:



1. Customer viewing the Navigation system map; and



2. Customer engaged in an active Bluetooth(R) telephone call.



If both of these conditions are encountered, a quiescent draw of approximately 1.5 amps on the battery may be induced, leading to the flat battery



situation.



Action:



In the event of a customer concern of the above and after ensuring proper electrical system checks have been carried out as referenced in the Land



Rover Battery Care Manual, refer to the Repair Procedure outlined below to update the Infotainment Control Module software.



PARTS:



No parts necessary



2010 Land Rover LR2 (LF) L6-3.2L Page 33



TOOLS



WARRANTY:



NOTE:



Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always



refer to DDW to obtain the latest repair time.



DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.



REPAIR PROCEDURE



UPDATE THE INFOTAINMENT CONTROL MODULE SOFTWARE



CAUTION:



Ensure all ignition "ON" / ignition "OFF" requests are carried out; failure to perform these steps may cause damage to control modules in the



vehicle.



CAUTION:



A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module programming.



1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.



2. Turn ignition ON (engine not running).



NOTE:



IDS must be loaded with IDS-DVD126_V6.01 or later and Calibration File 76 or later.



3. Connect the IDS to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.



4. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.



5. From the Session Type selection screen, choose "Diagnosis".



6. Select the Selected Symptoms tab, and then select:



^ Electrical > Battery > Charging system> Flat battery



7. Select "continue".



8. Select the Recommendations tab.



9. From the Recommendations tab, select Run to configure the Infotainment control module



^ Follow all on-screen instructions to complete this task.



10. Exit the current session.



11. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.

No comments:

Post a Comment