Engine Controls - Progman(R) V22.1/V22.1.1/V22.1.2

Engine Controls - Progman(R) V22.1/V22.1.1/V22.1.2

SI M 09 05 06

Programming/Coding Explanation

August 2006

Technical Service

SUBJECT

Release Notes Progman V22.1 and V22.1.1 and V22.1.2

MODEL

All

SITUATION

Progman V22.1 and V22.1.1 and V22.1.2 have been released. Certain errors may occur during installation or usage.

CAUSE

Software error

2002-2006 Mini Cooper (R50) L4-1.6L (W10) Page 226

COMPLAINT

The following issues are currently known:

1. "Back" button is missing after the "Change" button in the menu bar has been selected.

2. An incorrect CIP version may be displayed on the "Online update" screen after a JETStream update.

3. It may no longer be possible to use the GT1 after selecting "Update software".

4. In some cases, no status display (white screen) appears for a few minutes if a measures plan is cancelled.

5. No FASTA data has been transferred for a long period of time.

6. SSS enters service mode during the day, and it is no longer possible to start a session.

7. The user interface may show "# 4" following a full installation using Progman V21.2.

8. Retrofits and conversions may or may not be offered on vehicles with ZCS, even if they are or are not valid for the vehicle concerned.

9. Vehicle information may be exchanged between two simultaneous running sessions of same vehicle series.

10. Various errors may occur during replacement procedure.

11. The following error message may be displayed when an SSS is selected with GT1 or DISplus:

"The document contained no data. Please try again later or contact the server administrator".

12. If SSS name is changed it causes the SSS to reboot. After rebooting the new SSS name is then displayed on the "SSS overview" screen but not

transferred to the JETstream server. The workshop personnel are NOT restricted in their work, but they do see an incorrect SSS name on the

JETstream management console.

PROCEDURE

1. Button is hidden behind the "Minimize" button, no workaround.

2. Ignore the incorrect CIP version displayed.

3. Proceed as follows: 1. Disconnect the GT1 cable and wait until an error message notifies you of the loss of connection. 2. Reconnect the cable.

3. Update the SSS list. 4. Select the SSS again and end the session in the usual way.

4. Wait until the next screen appears. This may take a few minutes.

5. Check all FASTA and Online service settings. If everything is correct reinstall Progman. However, the existing FASTA data will be lost.

6. Go to "Operating Status" on the SSS, press "Cancel" and wait about 1-2 minutes.

7. Restart the system manually.

8. Ignore the retrofit and conversions offered in error.

9. Only program one vehicle of this series per SSS.

10. For replacement procedures use only one vehicle per SSS at a time.

11. Do not touch the button repeatedly as the link with the SSS is being established. A successful transfer is indicated by a light gray bar in the top

right corner.

12. After a change in the SSS name, call up the "Dealership data" screen. Carry out a manual transfer of the dealership data and reboot SSS.