Figure legend
- A -ConnectionTest cable 35-pin socket box
- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)
- 05 -35-pin socket box
- 050 -126-pin socket box
- 108 -Test cable 266 589 01 63 00
- N3/10 (ME-SFI [ME] control unit)
- II 1-63ConnectionTest cable
- III 64-126ConnectionTest cable
Warning!
- Connection A of test cable 108 may NOT be connected to connection B of the 126-pin socket box (050).
Continue to test with button F2
Check proportion of water in gasoline fuel.
Figure legend
- 043Pressure gage
- 055Measuring beaker
- 069Pressure hose(119 589 04 63 00)
Test sequence
- Switch off ignition.
- Connect test pressure gauge.
- Hold the open fuel line in measuring beaker (055).
- Switch on ignition.
- Insert bridge.:
- Bridge between sockets (F.2) 98 and (F.17) 113 of the 126-pole socket box tester.
- Component M3 (Fuel pump) runs.
- Drain off about 0.5 l fuel.
- Remove bridge.
Specified value
- Testing If water is present in the fuel, the fuel is cloudy.After being left for a few hours, the water settles on the bottom of the measuring
beaker.
- In cases of doubt, compare the fuel drained with proper fuel.
No comments:
Post a Comment