- X30/5 (Left voltage distributor (CAN) connector)
- Test connectors and wiring for CAN of engine compartment CAN control modules.
- Control unit
Communication with ECU required ( Measuring system )
1.1.3.4. Display CAN signals with the aid of the special tool 'Star Diagnosis CANtool'.
Important notes
- When CAN diagnosis is finished, the 8-pin CAN cable must be replaced with the diagnostic cable.
- Before values are read out from a control unit, the control unit must be reinitialized.
Continue with button F2
Test 1.1.3.4.1: Actual values via CAN ( Engine CAN bus )
1.1.3.4.1. Actual values via CAN ( Engine CAN bus )
Note
- The actual values shown on the following screens are only displayed and updated as long as the CAN bus is active.
Continue with button F2
Test 1.1.3.4.1.1: Cruise control
Test 1.1.3.4.1.2: Drive authorization
Test 1.1.3.4.1.3: Control unit-specific actual values :
Test 1.1.3.4.1.4: Electronic selector module
Test 1.1.3.4.1.5: Transmission control
Test 1.1.3.4.1.6: Motor electronics
Test 1.1.3.4.1.7: Steering column module
Test 1.1.3.4.1.8: Function-specific actual values :
1.1.3.4.1.1. Cruise control
Warning!Communication with ECU required.
1.1.3.4.1.2. Drive authorization
Warning!Communication with ECU required.
1.1.3.4.1.3. Control unit-specific actual values :
1.1.3.4.1.3. No further information available.
1.1.3.4.1.4. Electronic selector module
Warning!Communication with ECU required.
1.1.3.4.1.5. Transmission control
Warning!Communication with ECU required.
1.1.3.4.1.6. Motor electronics
Warning!Communication with ECU required.
1.1.3.4.1.7. Steering column module
Warning!Communication with ECU required.
No comments:
Post a Comment