2010 Cadillac Truck SRX FWD V6-3.0L Page 857
- Left Front Acceleration or Position Sensor Circuit High Voltage/Open
DTC C0670 0A
- Left Front Acceleration or Position Sensor Circuit Too Slow Transitions
DTC C0675 02
- Right Front Acceleration or Position Sensor Circuit Short to Ground
DTC C0675 05
- Right Front Acceleration or Position Sensor Circuit High Voltage/Open
DTC C0675 0A
- Right Front Acceleration or Position Sensor Circuit Too Slow Transitions
Diagnostic Fault Information
Circuit/System Description
The suspension control module supplies a 5 V reference voltage and a low reference to each vertical wheel acceleration sensor. The vertical wheel
acceleration sensors supply a signal of 0.5-4.5 V to the suspension control module.
Conditions for Running the DTC
System voltage is between 9-16 V.
Conditions for Setting the DTC
C0670 02 and C0675 02
The signal voltage is less than 0.5 V for 1.5 s.
C0670 05 and C0675 05
The signal voltage is greater than 4.5 V for 1.5 s.
C0670 0A and C0675 0A
* The number of signal changes is less than specified value for 2.5 s.
* Vehicle speed is greater than 30 km/h (19 mph).
Action Taken When the DTC Sets
* The electronic suspension control is disabled for the duration of the ignition cycle.
* The driver information center displays the SERVICE SUSPENSION SYSTEM message.
Conditions for Clearing the DTC
* A present DTC will clear on the next consecutive malfunction-free ignition cycle.
* A history DTC will clear after 41 consecutive malfunction-free ignition cycles.
Reference Information
Schematic Reference
Electronic Suspension Control Schematics (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic
)/Diagrams/Electrical Diagrams)
No comments:
Post a Comment