2010 Cadillac Truck SRX FWD V6-3.0L Page 1237

2010 Cadillac Truck SRX FWD V6-3.0L Page 1237

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC P162B

- Remote Vehicle Speed Limiting Signal Message Counter Incorrect

Circuit/System Description

When a remote slow-down request is sent from OnStar, the vehicle communication interface module sends a serial data message to the engine

control module (ECM) indicating that reduced vehicle speed has been requested. Once the request is active, the ECM begins reducing engine torque

to match requested vehicle speed and the REDUCED ENGINE POWER message is displayed.

Conditions for Running the DTC

* The engine run time is greater than 5 seconds.

* A remote slow-down request is sent from OnStar

Conditions for Setting the DTC

* The VIN embedded in the slow-down request does not match the VIN stored in the ECM.

* The rolling code counter embedded in the slow-down request does not increment for ten consecutive messages.

Action Taken When the DTC Sets

* ECM ignores all reduced vehicle speed request messages from the vehicle communication interface module.

* The ECM stores DTC P162B in history.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear after 40 malfunction-free ignition cycles have occurred.

Reference Information

Schematic Reference

OnStar Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/OnStar Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Remote Vehicle Speed Limiting Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description

and Operation/Remote Vehicle Speed Limiting)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Perform the scan tool Stolen Vehicle Slow-Down Clear. Verify DTC P162B is not set.

If the DTC is set, replace the vehicle communication interface module and retest. If the DTC sets again, replace the ECM.