Saturday, May 14, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1113

2010 Cadillac Truck SRX FWD V6-3.0L Page 1113



Conditions for Running the DTCs



* DTCs P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0128, P0335 or P0336 are not set.



* The engine is running.



* The engine coolant is between 69 and 127掳C (156 and 261掳F).



* The intake air temperature is between -20 and +125掳C (-4 and +257掳F).



* The DTC runs continuously when the above conditions are met.



Conditions for Setting the DTC



The engine control module (ECM) detects that the actual measured airflow from the MAF, MAP, and throttle position sensors is not within range of



the calculated airflow that is derived from the system of models for greater than 2 s.



Action Taken When the DTC Sets



DTC P0101 is a Type B DTC.



Conditions for Clearing the MIL/DTC



DTC P0101 is a Type B DTC.



Diagnostic Aids



* A steady or intermittent high resistance of 15 ohm or greater on the ignition voltage circuit will cause the MAF sensor signal to be increased



by as much as 60 g/s.



* Depending on the current ambient temperature, and the vehicle operating conditions, a MAF sensor signal circuit that is shorted to the IAT



signal circuit will cause the MAF sensor signal to be skewed or erratic. Additionally, it may cause a rapid fluctuation in the IAT Sensor



parameter.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

No comments:

Post a Comment