Saturday, February 26, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1407

2010 Cadillac Truck SRX FWD V6-3.0L Page 1407



* A lean or rich Q17 fuel injector-Refer to Fuel Injector Solenoid Coil Test (LAU) (See: Powertrain Management/Fuel Delivery and Air



Induction/Fuel Injector/Testing and Inspection)Fuel Injector Solenoid Coil Test (LF1, LFW) (See: Powertrain Management/Fuel



Delivery and Air Induction/Fuel Injector/Testing and Inspection).



* An engine mechanical condition-Refer to Symptoms - Engine Mechanical (See: Engine, Cooling and Exhaust/Engine/Testing and



Inspection/Symptom Related Diagnostic Procedures/Symptoms - Engine Mechanical).



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Spark Plug Replacement (See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Spark Plug/Service and



Repair)



* To verify that the performance of the catalytic converter has not been affected by the condition that set this DTC, perform the Repair



Verification for DTC P0420 or P0430. Refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code



Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) for DTC P0420 or P0430.



P0315



DTC P0315



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC P0315: Crankshaft Position System Variation Not Learned



Circuit/System Description



The crankshaft position system variation learn feature is used to calculate reference period errors caused by slight tolerance variations in the



crankshaft, and the crankshaft position sensor. The calculated error allows the engine control module (ECM) to accurately compensate for reference



period variations. This enhances the ability of the ECM to detect misfire events over a wider range of engine speed and load conditions.



The crankshaft position system variation compensating values are stored in ECM memory after a learn procedure has been performed and the



ignition switch is turned to the OFF position for at least 30 s. If the actual variation is not within the crankshaft position system variation



compensating values stored in the ECM, DTC P0300 may set.



If the crankshaft position system variation values are not stored in the ECM memory or a proper ECM power down does not occur after completing



the Crankshaft Position Learn Procedure, DTC P0315 sets.



Conditions for Running the DTC



DTC P0315 runs continuously.



Conditions for Setting the DTC



The ECM detects that the crankshaft position system variation values are not stored in memory.



Action Taken When the DTC Sets



DTC P0315 is a Type A DTC.



Conditions for Clearing the MIL/DTC



DTC P0315 is a Type A DTC.



Diagnostic Aids



This test procedure requires that the vehicle battery has passed a load test and is completely charged. Refer to Battery Inspection/Test (See:



Starting and Charging/Testing and Inspection/Component Tests and General Diagnostics/Battery Inspection/Test).

No comments:

Post a Comment