Sunday, February 20, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1110

2010 Cadillac Truck SRX FWD V6-3.0L Page 1110



* The ignition is ON, or the engine is operating.



* The ignition voltage is greater than 10 V.



* DTC P0100, P0102 and P0103 run continuously once the above conditions are met for 1 s.



Conditions for Setting the DTC



P0100



The ECM detects that the MAF sensor signal is 0.0 Hz.



P0102



The ECM detects that the MAF sensor signal is less than 1135 Hz.



P0103



The ECM detects that the MAF sensor signal is greater than 15,152 Hz.



Action Taken When the DTC Sets



DTCs P0100, P0102, and P0103 are Type B DTCs.



Conditions for Clearing the DTC



DTCs P0100, P0102, and P0103 are Type B DTCs.



Diagnostic Aids



* Inspect the harness of the MAF sensor to verify that it is not routed too close to the following components:



- The secondary ignition wires or coils



- Any solenoids



- Any relays



- Any motors



* Inspect the hydro-carbon (HC) absorber, if equipped, in the air cleaner assembly for ruptures that would leak charcoal into the air intake,



contaminating the sensing element.



* Inspect for any contamination, water intrusion, or debris on the sensing elements of the MAF sensor. If debris is present, clean the sensor. If



the sensor cannot be cleaned, replace the sensor.



* A high resistance may cause a driveability concern before this DTC sets.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Air Intake System Description (LF1)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)

No comments:

Post a Comment