2010 Cadillac Truck SRX FWD V6-3.0L Page 854

2010 Cadillac Truck SRX FWD V6-3.0L Page 854

瀚慖f less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,

replace the K19 suspension control module.

瀚慖f greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K19

suspension control module.

5. Verify the scan tool Vertical Body Acceleration parameter is less than -3 m/s(2).

瀚慖f greater than the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the K19 suspension

control module.

6. Install a fused jumper wire between the signal circuit terminal 2 and the low reference circuit terminal 3.

7. Verify the scan tool Vertical Body Acceleration parameter is greater than 3 m/s(2).

瀚慖f less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the K19 suspension control module.

8. If all circuits test normal, replace the B162 vertical body acceleration sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Electronic Suspension Front Vertical Accelerometer Replacement - Upper (See: Sensors and Switches/Sensors and Switches - Steering and

Suspension/Sensors and Switches - Suspension/Acceleration Sensor/Service and Repair/Electronic Suspension Front Vertical Accelerometer

Replacement - Upper)

* Electronic Suspension Rear Position Sensor Replacement (See: Sensors and Switches/Sensors and Switches - Steering and

Suspension/Sensors and Switches - Suspension/Ride Height Sensor/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for suspension control module replacement, setup

and programming

C0670

DTC C0670 or C0675

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C0670 02

- Left Front Acceleration or Position Sensor Circuit Short to Ground

DTC C0670 05

- Left Front Acceleration or Position Sensor Circuit High Voltage/Open

DTC C0670 0A

- Left Front Acceleration or Position Sensor Circuit Too Slow Transitions

DTC C0675 02

- Right Front Acceleration or Position Sensor Circuit Short to Ground

DTC C0675 05

- Right Front Acceleration or Position Sensor Circuit High Voltage/Open

DTC C0675 0A

- Right Front Acceleration or Position Sensor Circuit Too Slow Transitions

Diagnostic Fault Information