2010 Cadillac Truck SRX FWD V6-3.0L Page 961

2010 Cadillac Truck SRX FWD V6-3.0L Page 961

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0011

- Intake Camshaft Position System Performance Bank 1

DTC P0014

- Exhaust Camshaft Position System Performance Bank 1

DTC P0021

- Intake Camshaft Position System Performance Bank 2

DTC P0024

- Exhaust Camshaft Position System Performance Bank 2

Circuit/System Description

The camshaft position actuator system enables the Engine Control Module (ECM) to change the timing of the camshafts while the engine is

operating. The camshaft position actuator solenoid signal from the ECM is pulse width modulated (PWM). The ECM controls the camshaft position

actuator solenoid duty cycle by controlling the amount of solenoid ON time. The camshaft position actuator solenoid controls the advance or the

retard of each camshaft. The camshaft position actuator solenoid controls the oil flow that applies the pressure to advance or retard the camshafts.

Conditions for Running the DTC

* DTC P0010, P0013, P0020, P0023, P0016, P0017, P0018, P0019, P0335, P0336, P0340, P0341, P0345, P0346, P0365, P0366, P0390, and

P0391 is not set.

* The ignition voltage is greater than 11 V.

* The engine is operating.

* The desired camshaft position is not changing greater than 4.5 degrees for at least 1 s.

* Both of the desired and actual camshaft position actuator values cannot be greater than 20 degrees or less than 5 degrees.

* DTCs P0011, P0014, P0021, and P0024 run continuously once the above conditions are met.

Conditions for Setting the DTC

P0011 and P0021

The ECM detects the difference between the desired and actual camshaft position angle is greater than 5 degrees for greater 2.5 s.

P0014 and P0024

The ECM detects the difference between the desired and actual camshaft position angle is greater than 5 degrees for greater 10 s.

Action Taken When the DTC Sets

DTCs P0011, P0014, P0021, and P0024 are type B DTCs.

Conditions for Clearing the DTC

DTCs P0011, P0014, P0021, and P0024 are type B DTCs.

Diagnostic Aids

Inspect the engine for any recent engine mechanical repairs. An incorrectly installed camshaft, camshaft position actuator solenoid, mechanical

camshaft actuator, or timing chain can cause this DTC to set.

Reference Information

Schematic Reference

Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics

(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference