Friday, December 3, 2021

Disclaimer2010 Cadillac Truck Escalade EXT AWD V8-6.2L Technical Service Bulletin # 10-08-42-001C Date: 120126

Disclaimer2010 Cadillac Truck Escalade EXT AWD V8-6.2L Technical Service Bulletin # 10-08-42-001C Date: 120126



Lighting - Low Beam Headlamp(s) Inoperative



TECHNICAL



Bulletin No.: 10-08-42-001C



Date: January 26, 2012



Subject: Low Beam Headlamp Bulb Diagnosis/Replacement (Inspect Bulb and Connector)



Models:



2008-2011 Buick Enclave



2007-2011 Cadillac Escalade, Escalade ESV, Escalade EXT



2008-2011 Cadillac CTS, CTS-V



2010-2011 Cadillac CTS Sport Wagon, SRX



2006-2011 Chevrolet Impala



2007-2011 Chevrolet Avalanche, Silverado, Suburban, Tahoe



2008-2011 Chevrolet Malibu



2009-2011 Chevrolet Traverse



2010-2011 Chevrolet Equinox



2007-2011 GMC Acadia, Sierra, Yukon, Yukon XL, Yukon Denali, Yukon Denali XL



2010-2011 GMC Terrain



2006-2010 Pontiac G6



2007-2010 Saturn AURA, OUTLOOK



Attention:



This bulletin DOES NOT apply to vehicles equipped with High Intensity Discharge (HID) lamps.



Supercede:



This bulletin is being revised to update the models to include the Chevrolet Impala. Please discard Corporate Bulletin Number 10-08-42-001B



(Section 08 - Body and Accessories).



Condition



Some customers may comment that the low beam headlamp is inoperative.



Correction



DO NOT replace the entire headlamp assembly for this condition.



Replace the bulb and inspect the connector following the procedure below.



2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 109



1. Remove the headlamp bulb. Refer to Headlamp Bulb Replacement procedure in SI.



2. Inspect the connector.



- If the connector is NOT discolored or damaged, replace the bulb only. For bulb part numbers, see Headlamp Bulb (Low Beam) in Group



02.727 of the appropriate Parts Catalog.



- If the connector is discolored at the bulb interface, replace the connector (service pigtail listed below) and bulb.



Important



Use only Duraseal splice sleeves (salmon, P/N 19168446). Other splice sleeves may not protect the splice from moisture or



provide a good electrical connection. Refer to Splicing Copper Wire Using Splice Sleeves in SI for splicing procedures.



1. Cut the wires of the connector approximately 45 mm (1-3/4 in) from the connector and splice in the service pigtail connector. Ensure



that the splices are not above the connector when re-installing.



2. Replace the bulb.



3. Verify that the headlamp is fully functional.



Parts Information



Warranty Information



2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 110



For vehicles repaired under warranty, use the table.

No comments:

Post a Comment