Saturday, November 6, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 757

2010 Cadillac Truck SRX FWD V6-3.0L Page 757



replace the K17 Electronic Brake Control Module (EBCM).



7. If all circuits test normal, replace the B119 Multi-axis Acceleration Sensor and verify the DTC does not reset.



瀚慖f the DTC resets, replace the K17 Electronic Brake Control Module (EBCM).



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests)



* Vehicle Yaw Sensor with Vehicle Lateral and Longitudinal Accelerometer Replacement (See: Brakes and Traction Control/Antilock Brakes



/ Traction Control Systems/Yaw Rate Sensor/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM or Multi-axis Acceleration Sensor



replacement, programming and setup



C027B



DTC C027B



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC C027B 00



- Brake Booster Electric Vacuum Pump Malfunction



Diagnostic Fault Information



Circuit/System Description



The brake booster vacuum sensor measures the vacuum in the brake booster assembly. The electronic brake control module (EBCM) supplies a 5 V



reference and a low reference circuit to the brake booster vacuum sensor. The vacuum sensor supplies a voltage signal in relation to the pressure in



the brake booster to the EBCM. When the vacuum within the system drops, the EBCM turns ON the vacuum pump by providing ground to the



vacuum pump relay. The relay activates and supplies voltage to the brake booster pump motor.



Conditions for Running the DTC



Ignition ON



Conditions for Setting the DTC



The EBCM detects a vacuum leak.



Action Taken When the DTC Sets



The brake warning indicator turns ON.

No comments:

Post a Comment