2010 Cadillac Truck SRX FWD V6-3.0L Page 1045

2010 Cadillac Truck SRX FWD V6-3.0L Page 1045

shorted to a voltage by monitoring the feedback voltage.

Conditions for Running the DTC

* The engine speed is greater than 80 RPM.

* The ignition voltage is between 10-18 V.

* The ECM has commanded the bypass solenoid valve ON and OFF at least once during the ignition cycle.

* The DTCs run continuously once the above conditions are met.

Conditions for Setting the DTC

P0033

The ECM detects the bypass solenoid valve control circuit is open.

P0034

The ECM detects the bypass solenoid valve control circuit is shorted to ground.

P0035

The ECM detects the bypass solenoid valve control circuit is shorted to voltage.

Action Taken When the DTC Sets

DTC P0033, P0034, and P0035 are Type B DTCs.

Conditions for Clearing the DTC

DTC P0033, P0034, and P0035 are Type B DTCs.

Diagnostic Aids

If the condition is intermittent, move the related harnesses and connectors, with the engine operating, while monitoring the circuit status for the

component with a scan tool. The circuit status parameter changes from OK or Not Run to Malfunction if there is a condition with the circuit or a

connection.

Reference Information

Schematic Reference

Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics

(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Turbocharger System Description ()

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Note: If any Turbocharger circuit DTC is set, the Bypass Solenoid Valve output control may not function. It may be necessary to clear the