Friday, October 15, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 2033

2010 Cadillac Truck SRX AWD V6-3.0L Page 2033



瀚慖f greater than the specified range, test the low signal circuit for an open/high resistance or for a short to voltage. If the circuit tests



normal, replace the K20 ECM.



6. If all circuits test normal, test or replace the appropriate B52 HO2S.



Repair Instructions



Caution: Refer to Heated Oxygen Sensor Resistance Learn Reset Caution (See: Powertrain Management/Computers and Control



Systems/Oxygen Sensor/Service Precautions/Heated Oxygen Sensor Resistance Learn Reset Caution).



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 (LF1) (See: Powertrain Management/Computers and Control Systems/Oxygen



Sensor/Service and Repair/Heated Oxygen Sensor Replacement - Bank 1 Sensor 2)



* Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 (LF1) (See: Powertrain Management/Computers and Control Systems/Oxygen



Sensor/Service and Repair/Heated Oxygen Sensor Replacement - Bank 2 Sensor 2)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming



P2272



DTC P2270 or P2272 (LF1)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P2270



- HO2S Signal Stuck Lean Bank 1 Sensor 2



DTC P2272



- HO2S Signal Stuck Lean Bank 2 Sensor 2



Diagnostic Fault Information

No comments:

Post a Comment