Monday, September 27, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 363

2010 Cadillac Truck SRX FWD V6-3.0L Page 363



瀚慖f not the specified value, test the signal circuit terminal 4 for a short to ground. If the circuit tests normal, replace the K39 liftgate control



module.



4. Install a 3 A fused jumper wire between the signal circuit terminal 4 and ground. Verify the scan tool Liftgate Front Control Switch



parameter is Active.



瀚慖f not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the



K39 liftgate control module.



5. If all circuits test normal, test or replace the S45B liftgate control switch-interior.



Component Testing



1. Ignition OFF, disconnect the harness connector at the S45B liftgate control switch-interior.



2. Test for the values listed below between the signal terminal 3 and the ground terminal 1.



* 600-650 ohm in the Off position



* 125k-140k ohm in the 3/4 position



* 400k-415k ohm in the Max position



瀚慖f not within the specified ranges, replace the S45B liftgate control switch-interior.



3. Test for infinite resistance between the signal terminal 4 and the ground terminal 1 with the switch open.



瀚慖f not the specified value, replace the S45B liftgate control switch-interior.



4. Test for less than 3 ohm between the signal terminal 4 and the ground terminal 1 with the switch closed.



瀚慖f greater than the specified range, replace the S45B liftgate control switch-interior.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.



* Liftgate Actuator Control Switch Replacement (See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate



Motor/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for the liftgate control module replacement, setup



and programming



B396D



Liftgate Interior Release Open/Close Switch Malfunction - DTC B396C or B396D



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B396C 08



- Liftgate Mode Switch Circuit Performance Signal Invalid



DTC B396D 02



- Front Liftgate Actuator Switch Circuit Short To Ground



Diagnostic Fault Information

No comments:

Post a Comment