Monday, August 2, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 610

2010 Cadillac Truck SRX FWD V6-3.0L Page 610



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Verification



1. Perform the Vehicle Key Relearn procedure. Refer to Replacing Keys (See: Accessories and Optional Equipment/Antitheft and Alarm



Systems/Service and Repair/Replacing Keys).



2. While viewing the scan tool BCM Key Part Number parameter, turn ON the ignition with each of the available vehicle keys. The parameter



should read a Key Part Number with all available keys.



瀚慖f not the specified value, replace the appropriate key.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Replacing Keys (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and Repair/Replacing Keys)



B3101



DTC B3101



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B3101 00



- Keyless Entry Data Link Circuit



Diagnostic Fault Information



Circuit/System Description



The body control module (BCM) communicates with the remote control door lock receiver through the keyless entry serial data circuits. When any



button on the keyless entry transmitter is pressed, the transmitter sends a signal to the remote control door lock receiver. The remote control door



lock receiver sends a function request to the BCM, depending on which button is pressed on the transmitter. The BCM receives the message and



performs the appropriate function.



Conditions for Running the DTC



A button is pressed on the keyless entry transmitter.



Conditions for Setting the DTC



No response is received from the remote control door lock receiver after the BCM requests information from or sends configuration commands to



the remote control door lock receiver.



Action Taken When the DTC Sets



In the case of power failure, the remote control door lock receiver is disabled for 65 seconds, otherwise no action is taken.

No comments:

Post a Comment