2010 Cadillac Truck SRX AWD V6-3.0L Page 1659
* Throttle Body Assembly Replacement (LF1) (See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal and Replacement)Throttle Body Assembly Replacement (LAU) (See: Powertrain Management/Fuel Delivery and Air
Induction/Throttle Body/Service and Repair/Removal and Replacement)
* Crankshaft Position Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Crankshaft Position
Sensor/Service and Repair)
* Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (LF1) (See: Heating and Air Conditioning/Refrigerant Pressure Sensor /
Switch/Service and Repair)Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (LAU) (See: Heating and Air
Conditioning/Refrigerant Pressure Sensor / Switch/Service and Repair)
* Manifold Absolute Pressure Sensor Replacement (LF1) (See: Powertrain Management/Computers and Control Systems/Manifold
Pressure/Vacuum Sensor/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning)for engine control module replacement, setup, and
programming
P0700
DTC P0700
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each of the diagnostic category.
DTC Descriptor
DTC P0700
- Transmission Control Module (TCM) Requested MIL Illumination
Circuit/System Description
The diagnostic trouble code (DTC) indicates that an emission related transmission DTC set in the transmission control module (TCM). The engine
control module (ECM) receives the TCM information over the serial data circuit. The ECM turns ON the malfunction indicator lamp (MIL) when
the TCM sends a message over the serial data circuit requesting MIL illumination. The DTC information for the ECM will only display DTC
P0700, but the Freeze Frame/Failure Records data will display the transmission DTC that set.
Conditions for Running the DTC
* The ignition is ON or the engine is operating.
* DTC P0700 runs continuously.
Conditions for Setting the DTC
The ECM receives a serial data message from the TCM requesting the ECM to turn ON the MIL lamp.
Action Taken When the DTC Sets
DTC P0700 is a Type A DTC.
Conditions for Clearing the MIL/DTC
DTC P0700 is a Type A DTC.
Diagnostic Aids
Communication codes, U-codes, as well as powertrain codes, P-codes, set in the TCM can cause the TCM to request DTC P0700 to be set in the
ECM.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)
No comments:
Post a Comment