2010 Cadillac Truck SRX AWD V6-3.0L Page 2055

2010 Cadillac Truck SRX AWD V6-3.0L Page 2055

Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information

Circuit/System Testing

1. Verify that a test lamp illuminates between the G13 generator B+ terminal A X2 and ground.

瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

2. Ignition OFF, disconnect the X1 harness connector at the G13 generator.

3. Ignition ON, test for less than 1 V between the control circuit terminal 1 and ground.

瀚慖f greater than the specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the K20 ECM.

4. Engine running, test for greater than 3 V between the control circuit terminal 1 and ground.

瀚慖f less than the specified range, test the control circuit for a short to ground, or an open/high resistance. If the circuit tests normal, replace

the K20 ECM.

5. If all circuits test normal, test or replace the G13 generator.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Generator Replacement (LF1) (See: Starting and Charging/Charging System/Alternator/Service and Repair)Generator Replacement (LAU)

(See: Starting and Charging/Charging System/Alternator/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning)for ECM replacement, setup, and programming

Fuel Pump Control Module

DTC P2534 (Fuel Pump Control Module)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC P2534

- Ignition 1 Switch Circuit Low Voltage

Diagnostic Fault Information