Thursday, July 29, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 468

2010 Cadillac Truck SRX FWD V6-3.0L Page 468



* A history DTC will clear after 40 ignition cycles.



Reference Information



Schematic Reference



Door Lock/Indicator Schematics (See: Body and Frame/Locks/Diagrams/Electrical Diagrams/Door Lock/Indicator Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Power Door Locks Description and Operation (See: Body and Frame/Locks/Power Locks/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, observe the scan tool keyless entry control module Exterior Passenger Door Handle Switch parameter while pulling and releasing the



passenger door handle. The parameter should change between Active and Inactive as the handle is pulled and released.



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the B27B door handle switch - passenger exterior.



2. Ignition ON, verify the scan tool Exterior Passenger Door Handle Switch parameter is Inactive.



瀚慖f not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the K84 keyless entry



control module.



3. Install a 3 A fused jumper wire between the signal circuit terminal 2 and ground. Verify the scan tool Exterior Passenger Door Handle Switch



parameter is Active.



瀚慖f not the specified value, test the signal circuit terminal 2 for an open/high resistance. If the circuit tests normal, replace the K84 keyless



entry control module.



4. If all circuits test normal, test or replace the B27B door handle switch - passenger exterior.



Component Testing



Passenger Door Handle Switch



1. Ignition OFF, disconnect the harness connector at the B27B door handle switch - passenger exterior.



2. With the switch in the open position, test for infinite resistance between the signal terminal 2 and the ground terminal 1.



瀚慖f not the specified value, replace the B27B door handle switch - passenger exterior.



3. With the switch in the closed position, test for less than 5 ohm between the signal terminal 2 and the ground terminal 1



瀚慖f greater than the specified range, replace the B27B door handle switch - passenger exterior.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Front Side Door Outside Handle Replacement (See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Handle/Front



Door Exterior Handle/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for keyless entry control module replacement,



setup, and programming

No comments:

Post a Comment