Wednesday, July 21, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 473

2010 Cadillac Truck SRX FWD V6-3.0L Page 473



Conditions for Running the DTC



B1516 08



The BCM is awake.



B1516 66



* The BCM is awake.



* The engine is OFF.



Conditions for Setting the DTC



B1516 08



The battery current signal is less than 4 percent or greater than 96 percent duty cycle for 2 minutes.



B1516 66



The battery current polarity is positive for 2 minutes.



Action Taken When the DTC Sets



The regulated voltage control (RVC) is disabled.



Conditions for Clearing the DTC



The DTC passes when the battery current returns to the normal range for 15 seconds.



Diagnostic Aids



DTC B1516 08 could be set by overcharging with a battery charger or jump starting.



Reference Information



Schematic Reference



Starting and Charging Schematics (See: Starting and Charging/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Testing



B1516 08



1. Ignition OFF, disconnect the harness connector at the B18 battery current sensor.



2. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 20 Ohms between the low



reference circuit terminal B and ground.



瀚慖f greater than specified range , test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K9 BCM.



3. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal A and ground.



瀚慖f less than the specified range , test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,

No comments:

Post a Comment