2010 Cadillac Truck SRX FWD V6-3.0L Page 347

2010 Cadillac Truck SRX FWD V6-3.0L Page 347

瀚慖f not the specified value, replace the S79RR window switch-right rear.

4. Command the driver window to go UP, DOWN, express UP and express DOWN by using the S79D window switch-driver. The driver

window should perform the UP, DOWN, express UP and express DOWN functions.

瀚慖f the driver window does not perform as specified, refer to Driver Window Switch Malfunction.

5. Command the passenger window to go UP, DOWN, express UP and express DOWN by using the S79P window switch-passenger. The

passenger window should perform the UP, DOWN, express UP and express DOWN function.

瀚慖f the passenger window does not perform as specified, refer to Passenger Window Malfunction.

Circuit/System Testing

Driver Window Switch Malfunction

1. Ignition OFF, disconnect the harness connector at the S79D window switch-driver.

2. Ignition ON, verify that the scan tool Driver Window Main Control Down Switch parameter is Inactive.

瀚慖f not the specified value, test the control circuit terminal 3 for a short to ground. If the circuit tests normal, test or replace the M74D

window motor-driver.

3. Verify that the scan tool Driver Window Main Control Up Switch parameter is Inactive.

瀚慖f not the specified value, test the control circuit terminal 6 for a short to ground. If the circuit tests normal, test or replace the M74D

window motor-driver.

4. Verify that the scan tool Driver Window Main Control Express Switch parameter is Inactive.

瀚慖f not the specified value, test the control circuit terminal 2 for a short to ground. If the circuit tests normal, test or replace the M74D

window motor-driver.

5. If all circuits test normal, test or replace the S79D window switch-driver.

Passenger Switch Window Malfunction

1. Ignition OFF, disconnect the harness connector at the S79P window switch-passenger.

2. Ignition ON, test for greater than 10V between the signal circuit terminal listed below and ground:

* Signal circuit terminal 6

* Signal circuit terminal 7

* Signal circuit terminal 8

瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, test or

replace the M74P window motor-passenger.

3. If all circuits test normal, test or replace the S79P window switch-passenger.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Front Side Door Window and Multifunction Switch Replacement (See: Windows and Glass/Windows/Service and Repair/Front Side Door

Window and Multifunction Switch Replacement)

* Rear Side Door Window Switch Replacement (See: Windows and Glass/Windows/Service and Repair/Rear Side Door Window Switch

Replacement)

* Rear Side Door Window Regulator Motor Replacement (See: Windows and Glass/Windows/Service and Repair/Rear Side Door Window

Regulator Motor Replacement)

B324A

DTC B324A

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.