Sunday, July 25, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 402

2010 Cadillac Truck SRX FWD V6-3.0L Page 402



4. Verify that DTC B0954 3A, B0955 3A, B0956 3A or B0957 3A is not present.



瀚慖f DTC is present, replace the respective sensor with a sensor of correct sensor type.



5. Ignition ON, transmission in REVERSE, verify the scan tool Parking Assist System Status parameter displays Enabled.



Circuit/System Testing



1. Ignition OFF for 30 s, disconnect the harness connector at the appropriate front object sensor.



2. Test for less than 5 ohm between the low reference circuit terminal 2 and ground.



瀚慖f greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K41



Parking Assist Control Module.



3. Ignition ON, activate the park assist, test for 7.5-9.0 V between the 8 V reference circuit terminal 1 and ground.



瀚慖f less than the specified range, test the 8 V reference circuit for an open/high resistance. If the circuit tests normal, replace the K41



Parking Assist Control Module.



4. Ignition OFF, remove the malfunctioning object sensor and swap locations with another properly functioning front object sensor. Connect the



harness connector at both sensors.



5. Ignition ON, verify the DTC is set for the new location in which the malfunctioning sensor is installed.



瀚慖f the DTC does not set for the new location, test the signal circuit terminal 3 for a short to voltage, short to ground, or an open/high



resistance. If the circuit tests normal, replace the K41 Parking Assist Control Module.



6. If the DTC sets for the new location in which the malfunctioning sensor is installed, replace the appropriate front object sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Front Object Alarm Sensor Replacement (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist



Systems/Parking Assist Distance Sensor/Service and Repair/Front Object Alarm Sensor Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for parking assist control module replacement,



setup and programming



B0958



DTC B0958, B0959, B0960, or B0961



Diagnostic Instructions



^ Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



^ Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



^ Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B0958 01: Parking Aid Rear Sensor Left Corner Circuit Short to Battery



DTC B0958 06: Parking Aid Rear Sensor Left Corner Circuit Low Voltage/Open



DTC B0958 08: Parking Aid Rear Sensor Left Corner Circuit Performance - Signal Invalid



DTC B0958 21: Parking Aid Rear Sensor Left Corner Circuit Incorrect Period



DTC B0958 3A: Parking Aid Rear Sensor Left Corner Circuit Incorrect Component Installed



DTC B0959 01: Parking Aid Rear Sensor Left Middle Circuit Short to Battery



DTC B0959 06: Parking Aid Rear Sensor Left Middle Circuit Low Voltage/Open



DTC B0959 08: Parking Aid Rear Sensor Left Middle Circuit Performance - Signal Invalid

No comments:

Post a Comment