Thursday, July 8, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1688

2010 Cadillac Truck SRX AWD V6-3.0L Page 1688



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0722



- Output Speed Sensor (OSS) Circuit Low Voltage



DTC P0723



- Output Speed Sensor (OSS) Intermittent



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



The output speed sensor (OSS) is a hall-effect type sensor. The sensor faces the front differential transfer drive gear. The sensor receives 8.3-9.3



volts on the OSS supply voltage circuit from the transmission control module (TCM). As the output shaft rotates, the sensor produces a signal



frequency based on the machined surface of the output shaft. This signal is transmitted through the OSS signal circuit to the TCM. The TCM uses



the OSS signal to determine line pressure, transmission shift patterns, torque converter clutch (TCC) slip speed and gear ratio.



Conditions for Running the DTC



P0722



* No DTCs P0101, P0102, P0103, P0121, P0122, P0123, P0716, P0717, or P0723.



* The selected range is not PARK or NEUTRAL.



* The transmission input speed is between 1,000-6,500 RPM.



* The engine speed is between 3,200-5,000 RPM.



* The calc. throttle position is greater than 5 percent.



* The throttle position signal is valid.



* The engine torque is greater than 35 Nm (26 lb ft).



* The engine torque signal is valid.



* The TFT is greater than -40掳C (-40掳F).



* The engine speed is greater than 400 RPM for 5 seconds.



* The ignition voltage is 8.6 volts or greater.



P0723



* No DTCs P0101, P0102, P0103, P0121, P0122, P0123, P0723, P0973, P0974, P0976, P0977.



* Greater than 5 seconds since last range change.



* The engine speed is greater than 400 RPM for 5 seconds.



* The ignition voltage is greater than 8.6 volts.



Conditions for Setting the DTC

No comments:

Post a Comment