Sunday, July 18, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1706

2010 Cadillac Truck SRX AWD V6-3.0L Page 1706



* Output speed more than 500 RPM.



* Throttle position more than 10%.



* Measured gear ratio deviates more than 20% from expected ratio.



* Measured gear ratio deviates within 4% from 1st, 5th or 6th gear ratio.



* Determined after 12 times lasting 1 s or more.



Action Taken When the DTC Sets



* DTC P0734 is a Type C DTC.



* Torque limitation in "D" range 150 Nm (110 lb ft), in "R" range 170 Nm (125 lb ft).



* The TCM freezes transmission adaptive functions.



* The TCM turns OFF all solenoids.



* The TCM allows the vehicle after a stop to operate only in the second gear and "R" range.



Conditions for Clearing the DTC



* DTC P0734 is a Type C DTC.



* Measured gear ratio deviates less than 4% from expected ratio.



Diagnostic Aids



Ensure the transmission fluid level, color and odor is correct and there are no leaks. If there are any other transmission DTCs set, diagnose those



first.



Reference Information



Schematic Reference



Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams/Electrical



Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Description and Operation



Transmission Component and System Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/AF40-6 - Automatic Transmission/Transmission Component and System Description)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Verify the transmission fluid level, color and odor is correct.



2. Operate the vehicle to induce a shift from fifth to sixth gear while observing the following scan tool parameters. The scan tool parameters has



to change the proper value referring to the current gear, compare the proper values with: Transmission System Description and Operation



(M36 and MXE) (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/AF40-6 - Automatic



Transmission/Transmission System Description and Operation (M36 and MXE)). Perform this action 2 times.



* Clutch Pressure Control Solenoid Valve 1 Current



* Clutch Pressure Control Solenoid Valve 2 Current



* Clutch Pressure Control Solenoid Valve 3 Current



* Brake Band Pressure Control Solenoid Valve Current



* Shift Solenoid Valve 1



* Shift Solenoid Valve 2

No comments:

Post a Comment