Thursday, July 22, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1629

2010 Cadillac Truck SRX AWD V6-3.0L Page 1629



Circuit/System Verification



1. Observe the DTC information with a scan tool. DTC P0601, P0602, P0603, P0604, P0606, P062B, P062F, P0630, P16F3, or P2610 should



not set.



2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Circuit/System Testing



1. Ignition ON, clear the DTC information with a scan tool.



2. Observe the scan tool DTC information. Verify that DTC P0602 or P0630 does not set.



瀚慖f DTC P0602 or P0630 failed this ignition, reprogram the K20 ECM. Refer to Control Module References (See: Testing and



Inspection/Programming and Relearning). If the DTC resets, replace the K20 ECM.



3. Observe the DTC information with a scan tool. Verify that DTC P0601, P0603, P0604, P0606, P062B, P062F, P16F3, or P2610 does not set.



瀚慖f a DTC failed this ignition, replace the K20 ECM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and



programming



P0633



DTC P0633



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC P0633



- Immobilizer Key Not Programmed



Circuit/System Description



When learning the immobilizer data, as well as the challenge and response sequence, the engine control module (ECM) is placed in learn mode.



DTC P0633 will set automatically as an indicator that the system is in learn mode and not as a fault indicator. Once the immobilizer data and



challenge/response are learned, learn mode will be exited when the engine is successfully started. If the ECM does not exit learn mode, DTC P0633



will remain current and indicate a fault.



Conditions for Running the DTC



The ECM is in learn mode.



Conditions for Setting the DTC



DTC P0633 will set any time the ECM enters learn mode.



Action Taken When the DTC Sets



The security indicator in the instrument cluster will illuminate.



Conditions for Clearing the DTC



* A current DTC P0633 will be cleared upon a successful engine start after exit of learn mode.



* A history DTC will be cleared after 100 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.

No comments:

Post a Comment