2010 Cadillac Truck SRX AWD V6-3.0L Page 1912
5. If all circuits test normal, test or replace the transmission shift lever.
Component Testing
1. Ignition OFF, disconnect the harness connector at the transmission control.
2. Test for 6.74-6.94 k ohms between terminals A and B.
瀚慖f not within the specified range, replace the transmission control.
3. Test for 1.77-1.97 k ohms between terminals A and B while pressing the upshift button.
瀚慖f not within the specified range, replace the transmission control
4. Test for 3.87-4.07 k ohms between terminals A and B while pressing the downshift button.
瀚慖f not within the specified range, replace the transmission control.
Repair Instructions
Important:
* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and
Inspection/Programming and Relearning) following all transmission related repairs.
* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See:
Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General
Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Transmission Control Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and
Repair/6T70/6T75 - Automatic Transmission/Transmission Control Replacement) for AT TAP shift switch replacement.
* Control Module References (See: Testing and Inspection/Programming and Relearning) for body control module (BCM) or control solenoid
valve assembly replacement, setup, and programming
P1915
DTC P182E or P1915
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P182E
- Internal Mode Switch - Invalid Range
DTC P1915
- Internal Mode Switch Start/Wrong Range
Diagnostic Fault Information
Typical Scan Tool Data
No comments:
Post a Comment