2010 Cadillac Truck SRX AWD V6-3.0L Page 1846

2010 Cadillac Truck SRX AWD V6-3.0L Page 1846

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Control valve body replacement-Refer to Control Valve Body Replacement (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Valve Body/Service and Repair/AF40-6 - Automatic Transmission/Control Valve Body Replacement) for

replacement, setup and programming.

* TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup and

programming.

* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).

* Wiring harness-Refer to Automatic Transmission Wiring Harness Replacement (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Wiring Harness/Service and Repair) for replacement.

6T70/6T75 - Automatic Transmission

DTC P0973 or P0974

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0973

- Shift Solenoid (SS) 1 Control Circuit Low Voltage

DTC P0974

- Shift Solenoid (SS) 1 Control Circuit High Voltage

Diagnostic Fault Information

Circuit/System Description

The shift solenoid (SS) 1 is part of the control solenoid valve assembly, which has no serviceable components. SS 1 is a normally closed (NC)

ON/OFF solenoid and is controlled by the TCM through a low side driver. When the SS 1 is energized (ON), SS 1 fluid pressure is directed to the

clutch select valve 2, which allows the valve to overcome the spring pressure and move to the applied position. Power to the SS 1 is supplied by the

TCM through a high side driver (HSD). The HSD protects the circuit and components from excessive current flow. If excessive current flow is

detected, the HSD will turn OFF. When the fault is corrected, the HSD will reset.

Conditions for Running the DTC

P0973

* The engine speed is greater than 400 RPM for 5 seconds.

* The ignition voltage is 8.6 volts or greater.

* DTC P0973 has not set this ignition cycle.

P0974

* The engine speed is greater than 400 RPM for 5 seconds.

* The ignition voltage is 8.6 volts or greater.

* DTC P0974 has not set this ignition cycle.

Conditions for Setting the DTC

P0973

The control solenoid valve assembly detects a short to ground on the SS 1 control circuit for 2 seconds.