2010 Cadillac Truck SRX AWD V6-3.0L Page 1807

2010 Cadillac Truck SRX AWD V6-3.0L Page 1807

Circuit/System Testing

Command the Line Pressure Control Solenoid Valve with a scan tool. The value should change from 0.0-1.1 A.

If the value does not change, turn ignition OFF, remove the K71 Transmission Control Module. Connect a test lamp between the low reference

circuit terminal 1 X2 at the K71 Transmission Control Module and the voltage supply component circuit terminal 3 X2 at the K71 Transmission

Control Module. Command the Line Pressure Control Solenoid Valve with a scan tool. The test lamp has to illuminate brighter with increasing

current.

If the test lamp always illuminate or always does not illuminate, replace the K71 Transmission Control Module.

Component Testing

Static Test

1. Ignition OFF, remove the K71 Transmission Control Module.

2. Test for 5-5.6 ohm at 20掳C (68掳F) between the low reference circuit terminal 1 X2 and the voltage supply circuit terminal 3 X2.

瀚慖f less than the specified range, test the wiring harness for internal short. If the circuit test normal, replace the Q23 Line Pressure Control

Solenoid Valve.

3. Test for infinite resistance between each terminal and the low reference circuit terminal 1 X2 and also to the voltage supply circuit terminal 3

X2.

瀚慖f less than the specified range, replace the wiring harness.

4. If all circuit test normal, perform the Control Solenoid Valve Inspection (M36 and MXE) (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/AF40-6 - Automatic Transmission).

瀚慖f the inspection test normal, replace the valve body assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Control valve body replacement-Refer to Control Valve Body Replacement (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Valve Body/Service and Repair/AF40-6 - Automatic Transmission/Control Valve Body Replacement) for

replacement, setup and programming.

* TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup and

programming.

* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).

* Wiring harness-Refer to Automatic Transmission Wiring Harness Replacement (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Wiring Harness/Service and Repair) for replacement.

6T70/6T75 - Automatic Transmission

DTC P0965-P0967

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0965

- Clutch Pressure Control (PC) Solenoid 2 System Performance

DTC P0966

- Clutch Pressure Control (PC) Solenoid 2 Control Circuit Low Voltage

DTC P0967

- Clutch Pressure Control (PC) Solenoid 2 Control Circuit High Voltage

Diagnostic Fault Information