2010 Cadillac Truck SRX FWD V6-3.0L Page 721

2010 Cadillac Truck SRX FWD V6-3.0L Page 721

* The DTC will be current for as long as the fault is present.

* When the fault is no longer present, the DTC will be a history DTC.

* A history DTC will clear after 40 ignition cycles.

Reference Information

Schematic Reference

Trailer Connector/Provision Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System

Diagram/Trailer Connector/Provision Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, observe the function of the left trailer turn signal lamp and the right trailer turn signal lamp while commanding the Left Trailer Turn

Signal Lamp and the Right Trailer Turn Signal Lamp ON and OFF with a scan tool. The left trailer turn signal lamp and the right trailer turn signal

lamp should turn ON and OFF while changing between the commanded states.

Circuit/System Testing

1. Ignition OFF, disconnect the X1 harness connector at the K68 trailer lighting control module.

2. Test for infinite resistance between the control circuit terminal listed below and ground:

* Right trailer turn signal lamp control terminal 2

* Left trailer turn signal lamp control terminal 17

瀚慖f less than the specified value, test the control circuit for a short to ground. If the circuit tests normal, replace the X88 trailer connector.

3. Test for less than 1 ohm between the control circuit terminals listed below:

* Control terminal 2 at the K68 trailer lighting control module and control terminal 4 at the X88 trailer connector.

* Control terminal 17 at the K68 trailer lighting control module and control terminal 1 at the X88 trailer connector.

瀚慖f greater than the specified range, test the control circuit for a short to voltage or an open/high resistance.

4. If all the circuits test normal, replace the K68 trailer lighting control module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for trailer brake control module replacement,

programming and setup

Without U4G

DTC B3887 or B3888 (Without U4G)

Diagnostic Instructions