Wednesday, June 23, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 319

2010 Cadillac Truck SRX FWD V6-3.0L Page 319



Relay Test



1. Ignition OFF, disconnect the KR5 rear defogger relay.



2. Test for 60-180 ohm between terminals 85 and 86.



瀚慖f not within the specified range, replace the KR5 rear defogger relay.



3. Test for infinite resistance between the following terminals:



* 30 and 86



* 30 and 87



* 30 and 85



* 85 and 87



瀚慖f not the specified value, replace the KR5 rear defogger relay.



4. Install a 25A fused jumper wire between relay terminal 86 and 12V. Install a jumper wire between relay terminal 85 and ground. Test for less



than 2 ohm between terminals 30 and 87.



瀚慖f greater than the specified range, replace the KR5 rear defogger relay.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay



Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power



Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))



* Control Module References (See: Testing and Inspection/Programming and Relearning) for HVAC control module replacement, setup and



programming



B291A



DTC B291A



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B291A 39



- Content Theft Deterrent Assembly Internal Malfunction



Circuit/System Description



The content theft deterrent intrusion/inclination sensor performers an internal self-check to determine it is functioning properly.



Conditions for Running the DTC



* The ignition is OFF.



* The vehicle is in Park.



Conditions for Setting the DTC



The body control module (BCM) detects an internal failure within the content theft deterrent intrusion/inclination sensor.



Action Taken When the DTC Sets



The intrusion and inclination output is disabled.



Conditions for Clearing the DTC



* A current DTC is cleared when the conditions for setting the DTC are no longer present.

No comments:

Post a Comment