Saturday, June 19, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Technical Service Bulletin # 10-06-01-006 Date: 100726

2010 Cadillac Truck SRX AWD V6-3.0L Technical Service Bulletin # 10-06-01-006 Date: 100726



Engine - Drive Belt Noise Inspect Pulley



TECHNICAL



Bulletin No.: 10-06-01-006



Date: July 26, 2010



Subject: Intermittent or Continuous Drive Belt Noise (Inspect for Pulley Damage, Misalignment and/or Replace Drive Belt)



Models:



2010 Buick LaCrosse



2010 Cadillac SRX



2010 Chevrolet Equinox



2010 GMC Terrain



Equipped with 3.0L (RPO LF1) or 3.6L (RPO LLT) V6 Engine



Built Prior to February 27, 2010



Condition



Some customers may comment on an intermittent or continuous drive belt noise.



Cause



2010 Cadillac Truck SRX AWD V6-3.0L Page 237



This condition may be caused by any of the following:



- One or more of the accessory drive pulleys may be misaligned, bent or damaged.



- The power steering (PS) pump pulley may be misaligned due to improper mounting on the PS pump.



- The drive belt may need to be replaced.



Correction



1. Verify the intermittent or continuous drive belt noise condition exists.



瀚慖f the condition exists, proceed to Step 2.



瀚慖f the condition does not exist, then this bulletin does not apply.



2. Perform a visual inspection for damage to any accessory drive pulley or to the drive belt. Refer to Drive Belt Chirping, Squeal and Whine



Diagnosis in SI.



瀚慖f the diagnosis reveals a condition, then repair as needed.



瀚慖f the diagnosis does not reveal a condition, proceed to Step 3.



3. Remove the drive belt. Refer to Drive Belt Replacement in SI.



Important



To properly perform Step 4, you MUST refer to and follow the referenced procedure.



4. Inspect the PS pump pulley and determine if it is flush with the PS pump shaft on the FRONT side. Refer to Corporate Bulletin Number



08-06-01-008A, Diagnosing Accessory Drive Belt/Serpentine Belt Noise and Use of Laser Alignment Tool in SI.



瀚慖f the inspection reveals that the PS pump pulley is properly aligned, then replace the drive belt. Refer to Drive Belt Replacement in SI.



Parts Information



Warranty Information



For vehicles repaired under warranty, use the table.

No comments:

Post a Comment